(1) When an HPA is required: A person must obtain an HPA from the department before conducting a hydraulic project, unless the activity is exempt from this requirement as provided in subsection (2) of this section.
(2) No HPA is required for the following hydraulic projects:
(a) Installing oyster stakes, boundary markers, or property line markers by hand or with hand-held tools;
(b) Driving across an established ford (RCW
77.55.031);
(c) Remedial actions by the department of ecology or a person under a consent decree, order, or agreed order under RCW
70.105D.090 (RCW
77.55.061). Although no HPA is required, the department of ecology must ensure compliance with the substantive requirements of this chapter;
(d) Landscape management plans approved by the department and the department of natural resources under RCW
76.09.350(2) serve as an HPA for the life of the plan if fish are selected as one of the public resources covered under the plan (RCW
77.55.201);
(e) Removing derelict fishing gear according to the guidelines described in RCW
77.12.865 (RCW
77.55.041);
(f) Removing crab pots and other shellfish gear under a permit issued under RCW
77.70.500;
(g) An activity conducted solely to remove or control
Spartina (RCW
77.55.051);
(h) An activity conducted solely to remove or control purple loosestrife performed with hand-held tools, hand-held equipment, or equipment carried by a person (RCW
77.55.051);
(i) Installing or removing a portable boat hoist in a lake if the hoist:
(i) Is not permanently installed;
(ii) Does not have a frame length greater than fifteen feet;
(iii) Does not have armoring or other structures installed for a foundation or protection;
(iv) Does not have a canopy;
(v) Is not installed or removed using equipment operated on the bed;
(vi) Is not installed at the inlet or outlet of any stream;
(vii) Does not require any dredging, filling, pile driving, or any other bed modifications during installation or removal;
(viii) Is not modified during or after installation by adding docks, ramps, floats, or other structures that add surface area to the hoist or allow for moorage of additional watercraft; and
(ix) Is not installed in any of the following sockeye salmon-bearing lakes during times of the year when spawning and egg incubation is occurring in beach areas:
Table 1
Authorized Work Times to Install Portable Boat Hoists in Lakes with Sockeye Spawning Beaches
Lake Name and Water Resource Inventory Area ((WRIA) in parentheses) | Authorized Work Times |
Baker (04) | June 15 - August 15 |
Cle Elum (39) | September 1 - March 31 |
Osoyoos (49) | May 15 - September 30 |
Ozette (20) | August 1 - October 31 |
Pleasant (20) | August 1 - October 31 |
Sammamish (08) | July 15 - September 30 |
Washington (08) | July 15 - September 30 |
(j) Installing, maintaining, or removing scientific measurement devices if:
(i) All work conducted waterward of the OHWL is done by hand or with hand-held tools;
(ii) The project does not create a blockage to fish passage, even temporarily; and
(iii) The project does not include dewatering the job site, placing fill or concrete, or excavating or grading the bed or bank.
(k) Forest practices hydraulic projects, as defined in chapter
76.09 RCW and governed in Title 222 WAC; and
(l) Installation or maintenance of tideland and floating private sector commercial fish and shellfish culture facilities (RCW
77.12.047). However, an HPA is required to construct accessory hydraulic structures, such as bulkheads or boat ramps.