WAC 296-864-40020:

WACs > Title 296 > Chapter 296-864 > Section 296-864-40020

HTML has links - PDF has Authentication

Print This Page

296-864-40015 << 296-864-40020 >> 296-864-500

Agency filings affecting this section

PDFWAC 296-864-40020

Follow these procedures for inflating split rim wheels.

You must follow the relevant procedures in Table 3, Procedures for Inflating Split Rim Wheels.

Table 3

Procedures for Inflating Split Rim Wheels

During these times:	Then:
Split rim wheels are being inflated.	Make sure employees stay out of the trajectory.
When all of the following occur:	The tire may be inflated while the rim wheel is on the vehicle.
A tire on a vehicle has more than 80 percent of the recommended pressure; and
Remote control inflation equipment is used; and
No employees are in the trajectory during inflation.
Assembly of the wheel and inflation of the tire.	Apply rubber lubricant to bead and rim mating surfaces, unless the tire or wheel manufacturer recommends against it.
Inflating tires outside of a restraining device.	Make sure you do not exceed 5 psi (pounds per square inch) to seat the bead.
The tire is pressurized.	Make sure you don't correct the seating of side and lock rings by hammering, striking or forcing the components.

Note:	1. Employees should stay out of the trajectory as much as possible while installing the split rim wheel onto the vehicle.
	2. The trajectory may deviate from its expected path.

[Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050, 49.17.060. WSR 15-24-102, § 296-864-40020, filed 12/1/15, effective 1/5/16; WSR 04-20-079, § 296-864-40020, filed 10/5/04, effective 2/1/05.]